Voice Commands for Setting Parameters
The following commands allow the temporary setting of preference values.
| display preferences | Displays the current preference values |
| calibrate quad stick | Recalibrates the joystick center position and pressure sensors |
| use USB [(A=1 | B=0)] | Selects the desired USB port as the active port |
| set mouse speed 1..250 [percent] | Sets the mouse speed |
| set volume | Set the speaker volume |
| set brightness | Set the LED brightness |
| set digital out 1..2 | Set the state of a digital output |
| set sip puff soft 2..20 | Set the sip/puff soft threshold |
| set sip puff 30..90 | Set the sip/puff hard threshold |
| set sip puff maximum 50..100 | Set the pressure to scale as 100% analog value |
| set sip puff delay 1..20 hundred | Set the delay to active a soft sip/puff |
| joy stick deflection minimum 1..20 | Set the deflection the joystick starts to output |
| joy stick deflection maximum 10..100 | Set the deflection the joystick scales to 100% |
| D pad inner 1..100 | Set the deflection for the inner d-pad zone |
| D pad outer 20..100 | Set the deflection for the output d-pad zone |
| joy stick dead zone (circle | square) | Set the dead zone shape |
Using the USB-A port requires a special cable. This use of the USB-A port is "off-spec", so while it has worked on each host we tested, it is not guaranteed to work.